QtiSAS|QtiKWS

SANS: reduction, analysis, global instrumental fit

User Tools

Site Tools

Action disabled: index

Sidebar


Vitaliy Pipich


Contact Form


SANS@Tools



SANS
Data
Reduction


ascii
SANS
1D


Compile
Fitting
Function

Fitting
Curve(s)
Tools


Singular
Value De-
composition


Jülich
NSE
Tools


SLD: Calculator


SANS@ToDo

SANS@MLZ




Very Small Angle Scattering KWS-3 ‘VerySANS’ www.verysans.com

JCNS :: Institutes

dan-sans:qtisas-dan-kws3-std

KWS-1@Data-Reduction-Example

DAN-SANS :: KWS-3 :: Standard Mode :: Data Reduction Introduction



In this introduction everybody could process raw-data obtained at KWS-3 SANS instrument both virtually (looking to more than 100 pages of step-by-step introduction) as well practically at own computer (raw-data is attached also).

  • Info-Table was generated to get information about raw-data located in the data-folder
  • Three sample in the example were measured in two instrument configurations: 9.2m and 1.2m
  • Standard mask-matrix “mask” is used for sensitivity matrix “sens”, for absolute calibration and for beam center calculation
  • For every instrument configuration two masks are created: for radial averaging (masked direct beam) and for transmission calculation (only direct beam place is not masked)
  • Table of configurations was filled step-by-step.
  • Script Table was automatically generated
  • Transmission was calculated for every configuration using the direct beam method (we measured without beam-stop)
  • Radial Averaging and merging with the standard mask are shown
  • Matrixes of the detector images were calculated (fully corrected): scattering signal was not ISOTROPIC
  • Radial Averaging and merging with the “vertical” and “horizontal” masks are shown
  • Data, measured at 1.2m were normalised to the ratio of transmissions measured at 1.2m and 9.2m

dan-sans/qtisas-dan-kws3-std.txt · Last modified: 2021/12/29 02:03 by Vitaliy Pipich